Owner's manual

ManualsBrandsStar Headlight & Lantern ManualsLighting201ZL Series

PLITSTR383 REV. D 4/16/14

INSTALLATION AND INSTRUCTION MANUAL

200ZL

SERIES

201ZL

SERIES

203MVL

SERIES

204MVL

SERIES

Magnet Mounting

If you are mounting the light on the roof of your vehicle, take extreme care to ensure that the magnet is

firmly seated on your roof, and that the pull of the magnet is sufficient to secure the light in place. As the

composition of the metal in the roofs of different vehicles may vary, as well as the contour, texture and/or

condition, Star cannot guarantee the ability of the light to remain in place upon a moving vehicle. It is the

sole responsibility of the owner to ensure the warning light is secure.

WARNING!!!! Care should be taken when positioning any warning light on the roof,

dash, or instrument panel of the vehicle, so that the light and/or cord

does not interfere with the proper operation of any airbags! Failure to

heed this warning may result in serious or fatal injury.

• CAUTION: Please be sure to check that your cigarette plug outlet is properly fused.

Testing the light before this fuse is properly installed will void the warranty on

the light.

• This light has been factory tested and approved. If the light fails to work when the

plug is inserted into the cigarette plug socket, twist the plug a few times to remove

any ash or other deposits which might be preventing a good contact from being

made. If the problem persists, check for a fuse inside of the plug itself. If present,

remove the fuse from the circuit, check to see if it has blown, and clean the lighter

socket and contact surfaces. Reconnect the fuse and test the light again.

LED FIVE YEAR LIMITED WARRANTY

The manufacturer warrants this LED light against factory defects in material and workmanship for five years after

the date of purchase. The owner will be responsible for returning to the Service Center any defective item(s)

with the transportation costs prepaid. The manufacturer will, without charge, repair or replace at its option,

products, or part(s), which its inspection determines to be defective. Repaired or replacement item(s) will be

returned to the purchaser with transportation costs prepaid from the service point. A copy of the purchaser's

receipt must be returned with the defective item(s) in order to qualify for the warranty coverage. Exclusions

from this warranty include, but are not limited to, domes, and/or the finish. This warranty shall not apply to any

light, which has been altered, such that in the manufacturer's judgment, the performance or reliability has been

affected, or if any damage has resulted from abnormal use or service.

There are no warranties expressed or implied (including any warranty of merchantability or fitness), which extend

this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or consequen-

tial damages, including costs of any labor, are not covered. The manufacturer reserves the right to change the

design of the product without assuming any obligation to modify any product previously manufactured.

This warranty gives you specific legal rights. You might also have additional rights that may vary from state to

state. Some states do not allow limitations on how long an implied warranty lasts. Some states do not allow the

exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or exclusion(s)

may not apply to you.

Summary of content (4 pages)

PAGE 1
INSTALLATION AND INSTRUCTION MANUAL 200ZL SERIES 201ZL SERIES 203MVL SERIES 204MVL SERIES Magnet Mounting WARNING!!!! Care should be taken when positioning any warning light on the roof, dash, or instrument panel of the vehicle, so that the light and/or cord does not interfere with the proper operation of any airbags! Failure to heed this warning may result in serious or fatal injury.
PAGE 2
CAUTION !! All of our DC powered warning lights are polarity sensitive. These lights are polarity protected only if the appropriate fuse is used. All wires connected to the positive terminal of the battery should be fused at the battery for their rated load. Testing the light before this fuse is properly installed will void the warranty on the light. 200ZL and 201ZL Permanent Mounting 1.
PAGE 3
203MVL and 204MVL Permanent Mounting Your new warning light comes complete with the following: Please note that these models only use (2) of the following: Mounting screws, Lock washers, and Hex nuts (1) Light (3) Mounting screws (1) Foam mounting gasket (1) Wire grommet (2) Wire splicing terminals 1. Where applicable, carefully remove the headliner from the inside of the vehicle so that it is not damaged during installation of the light. 2. Remove the foam gasket from the shipping box.
PAGE 4
Pattern Selection Depending upon your model, pressing the pattern select button on the cig plug, or touching the green wire to ground on hard-wired models, will allow you to program the desired flash pattern. The unit has 28 patterns to choose from. After the final pattern is reached, the patterns will cycle through again. The UNIT will remember the pattern it was in when turned off and display the same pattern when re-activated. Patterns 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.