Owner's manual

-2-
QUICK-INSTALL WIRING GUIDE
14-Wire Harness Wiring (271-TOWBAR)
Light Blue Optional - High/Low (Ground for low intensity)
Orange Rear Enable (Turns on Rear Facing M-Tech Plus™ Lights)
Yellow Left Stop (+12VDC Only - Used only if you have STT lights in your bar)
Green Right Stop (+12VDC Only - Used only if you have STT lights in your bar)
White w/Orange Work Lights (+12VDC Only - Used only if you have worklights in your bar)
Brown Tail (+12VDC Only - Used only if I.D. or STT lights are in your bar)
Red
Power (Connect to constant +12-24 VDC
†
)
Red w/White
Scene Lights
Red w/Green
Passenger Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
Black w/Green
Driver Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
White w/Green Front Enable (Turns on Front Facing M-Tech Plus™ Lights)
Gray Synchronization (Used to synchronize two or more lights together)
Black Ground (Connect to the negative side of the battery)
Bare Ground (Shield - Connect to a good chassis ground)
16-Wire Harness Wiring (271-STROBE)
Light Blue Driver Side Alley Light (Switched +12VDC Only)
White w/Brown Pursuit (Used only if Pursuit lights are in your bar)
White w/Blue ICL Power (Intersection Clearing Lights)
Green w/Yellow Takedowns (Used only if Takedown lights are in your bar)
Red
Power (Connect to constant +12-24 VDC
†
)
Red w/Black
Driver Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
Red w/White Synchronization (Used to synchronize two or more lights together)
Red w/Green
Passenger Side Pattern Select (Touch and release to +12-24 VDC to
change patterns)
Black w/Green Rear Enable (Turns on Rear Facing M-Tech Plus™ Lights)
White w/Green Front Enable (Turns on Front Facing M-Tech Plus™ Lights)
Orange Not Used or Optional Component
White Rear Flashers (Used only if Rear Flashers are in your bar)
Orange w/Red Optional - High/Low (Ground for low intensity)
Gray
Passenger Alley (Switched +12VDC Only)
Black Ground (Connect to the negative side of the battery)
Bare Ground (Shield - Connect to a good chassis ground)
WIRE COLORS AND FUNCTIONS WILL VARY FROM HARNESS TO
HARNESS. PLEASE BE SURE TO CORRECTLY IDENTIFY YOUR
HARNESS AND USE THE CORRESPONDING TABLE. IN ADDITION, ALL
LIGHTBARS ARE SHIPPED WITH A WORKSHEET THAT IDENTIFIES THE
FUNCTION FOR EACH WIRE COLOR IN THAT SPECIFIC LIGHTBAR.
!
† - The Red wire MUST be connected to +12VDC for the front and rear warning LEDs to operate. If you
are NOT utilizing a separate Front and Rear enable function, you may connect the Red wire, along
with the Front enable wire and Rear Enable wire to +12-24VDC through your On/Off switch. If you
ARE using a separate Front and Rear Enable function, connect the Red wire to constant +12-24VDC.
Please note: When the red POWER wire is connected to constant power the light will draw a small
current (20 mA). If your vehicle will be sitting for extended periods of time (i.e. more than a few
days), it is recommended all power wires be routed through an ignition switched power source.