Datasheet
-
19
-
2
∼
3mm
4. Attaching the Accessories
e following accessories are necessary when mounting the printer to a wall.
• Holder plate and two angeless screws
e following accessories are necessary when positioning the printer vertically.
• Four rubber feet
e following accessories do not necessarily have to be attached. Attach it if necessary.
• Switch cover
4-1. Attaching the Holder Plate
<Precoutions>
n e holder plate is attached to the printer using the included screws and is hooked onto screws that are installed
into the wall.
n e screws on the wall are not included.
Use commercially available screws (4 mm diameter) that are suitable for the wall material (wood, steel beam,
concrete, etc.).
n e printer’s weight is approximately 2.4 kg when the largest diameter roll paper is loaded.
Use screws on the wall that have both shear strength and pulling-out strength to withstand a force of at least
12 kgf (118 N).
(1) Attach the holding plate to the printer. en tighten the two screws that were supplied to secure it in place.
(2) Position the printer over the screws, etc., on the wall and then slide it downward to set it in place.
Aer setting the printer in place, check the screws on the wall again to make sure that they are able to support the
printer’s weight.