Printer User Manual

4 Printer Setup
Opening the front cover
❏
Lift up on the front cover and swing it open until it stops.
❏ To close the front cover, simply lower it back into place.
Caution!
The tear assist edge is rather sharp. Take care to avoid injuring your hands.
Note:
You can completely remove the front cover from the printer or you can stand it
up. You should normally leave the front cover closed, because it protects
against objects getting into the printer, and it cuts down on printer noise.
Removing the protective materials
Two small pieces of packing material are inserted into the printer to protect
components during shipping. Be sure to remove them before using the printer.
❏ Open the rear cover by pushing it back so that the cover swings back and
down.
Tear assist edge