Printer User Manual

42 User Setup Utility

When you start the User Setup Utility, it reads and displays the last settings

that were sent to the printer by the utility.

Note:

The utility does not read the settings from the printer. It reads the settings from

a ﬁle that was created the last time the utility was run, which are stored on your

computer’s hard disk. If the EDS settings have been changed using the

printer’s control panel, those control panel settings will not be shown by the

utility, and they will be replaced by the current User Setup Utility settings if

you specify that current settings should be sent to the printer (page 45) when

you exit the utility.

❏ Now you can use the User Setup Utility to make the setup changes you

want.

You can press the F1 function key at any time to access on-screen help for

the setup utility.

Changing the General, Font, Paper and Adjust Settings

The following are basic operations to change settings in the General, Font,

Paper and Adjust windows.

To select a window

❏ Click on the name of the window you want to select (General, Font,

Paper, Adjust, Port) by clicking on its name at the top of your computer’s

screen. When you do, the corresponding window appears on the screen.

You can also select a window by pressing a function key from F4 to F8.

General

Standard

Emulation

Input Buffer

RAM usage

Disabled

Quiet mode

Bi-direction

Graphic Direction

Long

CR Centering Position

Help

Exit

File

Font

Paper

Adjust

Port

General