- Micronics Co.. Ltd. Opration Manual printer LS-5 EX, LS-5 TT

Safety Notices
This printer iscertifiedw a Class I ImerpmchrctuncfertheU.S.Departmentof HealthandHumanServices
(DHHS) Radiation Performance Standard accordingto the RadiationControl fbr Health and Safety Act
of 1968.This means that the printer does not emit hazardous laser radiation.
Since radiation emitted insidethe printer iscompletelyconfined within protective housingsandexternal
covers, the laser beam cannot escape from the machine during any phase of user operation.
The Center for Devices and Radiological Health (CDRH) of’the U.S.Food and Drug Administmtirm
implementedregulations kmlaser products onAugust 1, 1976,These regulationsapplytn laserproducts
mwketed !nthe United States, The label on tbe printer indicatescompliance with the CDRH regulations
and must be attfichedto laser products marketed in the L’nitedSt:ites,
Caution-use of’crrntrolsor adjustments or performance of procedures other than thnse specified herein
may result in hazardous radiation exposure.
Federal Communications Commission
Radio Frequency Interference Statement
Tbisequipment has beentested and found to comply with the limits fora Class Bdigital device, pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable pmtectinn against harmful
interference in a residential installation.This equipmentgenerates, uses andcan radiate radio frequency
energy and, if not installedand used in accordancewith the instructions,maycausebarmf’ulinterference
to radio communications. However. there is no guaranteethat interference will not occur in a particular
installation. If tbis equipment does cause harmful interferenceto radioor television reception. whichcan
bedetermined by turningthe equipmentoffandon, the user isencouraged totrytoccsmectthe interference
by one or more of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between tbe equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to wbich the receiver is
connected.
o Consult the dealer or an experienced radio/TV technician for help.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielciedcable.
Th(,Oh(],,(,rtuten,(tlisupp[>0111>to printers marketed in the U.S.A.
VDE Statement
This device’carries tbe VDE RFI protection mark to certify that it meets tbe radio interference
requirements of the Postal Ordinance No. 243/1991. The additional marking “Vfg. 243/P” expresses in
short form that this is a peripheral device (not operable alone) wbich only individwdly meets the Class
B RFI requirements in accordance with the DIN VDE 0878 part 3/11.89and the Postal Ordinance 243/
1991.
If this device is operated inconjunction with other devices within a set-up, in order to take advantage of
a ‘“General(Operating) Authorization”inaccordancewith the Postal Ordinance 243/1991, the complete
set-up must comply with the Clkss B limits in accordancewith the DIN VDE 0878 part 3/11.89,as well
as satisfy the preconditions in accordance with $ ‘2and the prerequisites in accordance with $ 3 of the
Postal Ordinance 243/1991.
As a rule, this is only fulfilled when the device is operated in a set-up which has been type-tested and
provided with a VDE RFI protection mark with the additional marking “Vfg 243”.
Macbine Noise Information Ordinance 3. GSGV, January 18, 1991: The sound pressule level It the
operator position is equal m less than 70 dB(A) according to 1S0 7779.
T/7eutx)~>cstuteniei7r tipp[iesOIIIV10[Irit?tersmarLefed if]GewmrtI>