Multi-Font User's Manual

Table Of Contents

LOADING SINGLE SHEETS

This section will take you through the procedures for loading single sheets

of paper.

Loading the paper without optional accessories

If you are using the optional Automatic Sheet Feeder, refer to next section.

1. Place the paper guide in position by inserting the tabs, located on the

bottom of the assembly, into the slots on the rear cover of the printer.

Paper guide

Figum d-12. Mounting the paper guide for single sheets.

2. Adjust the paper guides to match the size of the paper you will be using.

Remember that printing will start some distance from the left-hand edge

of the carriage.

3. Turn on the power using the switch located at the front of the printer. The

printer will beep, indicating that there is no paper in position for printing.

The PAPER indicator will also illuminate to confirm this.

4. Make sure that the release lever is at front position.

If fanfold paper is already mounted in the printer, press the

aET’EJECf 1

button to park the paper in the off-line state, then move the

release lever forward.