Multi-Font User's Manual
Table Of Contents
- 挀漀瘀攀爀
- 䠀伀圀 吀伀 唀匀䔀 吀䠀䤀匀 䴀䄀一唀䄀䰀
- 吀䄀䈀䰀䔀 伀䘀 䌀伀一吀䔀一吀匀
- 䌀栀愀瀀琀攀爀 䤀一吀刀伀䐀唀䌀吀䤀伀一
- 䌀栀愀瀀琀攀爀 ㈀ 匀䔀吀吀䤀一䜀 唀倀 吀䠀䔀 倀刀䤀一吀䔀刀
- 䌀栀愀瀀琀攀爀 ㌀ 伀倀吀䤀伀一䄀䰀 䄀䌀䌀䔀匀匀伀刀䤀䔀匀
- 䌀栀愀瀀琀攀爀 㐀 倀䄀倀䔀刀 䤀一匀吀䄀䰀䰀䄀吀䤀伀一 䄀一䐀 唀匀䔀
- 䌀栀愀瀀琀攀爀 㔀 䌀伀一吀刀伀䰀 倀䄀一䔀䰀 伀倀䔀刀䄀吀䤀伀一匀
- 䌀栀愀瀀琀攀爀 㘀 匀䔀吀吀䤀一䜀 吀䠀䔀 䴀䔀䴀伀刀夀 匀圀䤀吀䌀䠀䔀匀
- 䌀栀愀瀀琀攀爀 㜀 倀刀䤀一吀䔀刀 䌀伀一吀刀伀䰀 䌀伀䴀䴀䄀一䐀匀
Loading the paper with optional Automatic Sheet
Feeder
If you are not using the optional Automatic Sheet Feeder, refer to the
previous section.
1. Install the optional Automatic Sheet Feeder as described in Chapter 3.
-
F/gun 4-14. Install the optional Automatic Sheet Feeder.
2. Use the printer’s Memory Switchmode to select ASF. (For details, please
refer to Chapter 6.)
-
3. If fanfold paper has already been loaded in the printer, park the paper
-
through the rear slot.
-
4. Pull the printer release lever forward to load single sheets.
5. When you areusingSingle-BinASF,pullthepaperloadingleverforward
to pull the hopper out until it is in position.
In case of the Dual-Bin ASF, pull both pressure bar levers forward to
open the pressure bar.
38
.-