Multi-Font User's Manual

2. With the tractor covers open, mount the paper from the bottom of the
printer, by aligning holes with the pins on the tractor unit.
F/gum 4-7. Mount the fanfold paper from the bottom of the printer.
3. Adjust the spacing of the tractor units by sliding them along the bar, using
the clamp lever at the back of each unit to release and lock them in
position. When the lever is up, the unit is released, and when it is down,
the unit is locked.
4. Now close the tractor covers, again making sure that the paper holes are
aligned with the pins on the tractor units. If they are not aligned properly,
you will have problems with paper feeding, possibly resulting in tearing
and jamming of the paper.
Loading the paper with Push/Pull feed
You canload the fanfold paper with Push/Pull feed by using both the internal
push tractor unit and the optional Pull Tractor Unit.
1. Place a stack of fanfold paper behind and at least one page-length below
the printer.
2. Turn the printer’s power OFF.
3. Push the releaseleverbackward. This has the effect of releasing the paper
from the platen roller, and engaging the tractor feed.