Multi-Font User's Manual

Paperfeeding
If cut sheet paper (without ASF) is not feeding smoothly, check the
following:
Check
Is the paper release
lever
pushedfront(tothe~ posi-
tion)?
Is the paperguide in place
and vertical?
Are the left andrightguides
too close together?
Is the ASF selected with the
MemorySwitch settin~?
Areyou trying to feed paper
using thefrontpanelbuttons
white the ONLINE
indicator
illuminated?
Is the paper
toothick?
Are forms jammingbetween
printing surface and the
platen?
Possible remedy
Set the release lever to the ~ position.
Thepaperguideshouldbeinplaceandverticallyforcut
sheets to feed smoothly.
If the left and right guides me too close together, the
paper will not feed smoothly. Move them a little further
auart to allow the pauer feed freely.
If it is,
then deselect it.
You can only feed paper in this way the printer is off-
line. Set the printer off-line and then feed paper.
There are limits to the thickness of paper that can be fed
in this way. Trv with thinner uamx.
Clean the surface of theplatenroller with acloth barely
dampendcd with a little alcohol.
Iffanfold(continuous)paperisnotbeingfedcotnctly usingtheaactorfeed,
checkthe following:
Check
Possible remedy
Is the paper release lever
Makesuretherelease lever ispushcdto the ~ position.
pushed to the ~ position?
Is the paper guide in the ver-
When using the tractor feed, the paper guide should be
tical position?
horizontal.
Are the holes on each side of
the paper aligned with regard
to each other in the tractor
If thetwosides of thepaperareoutof alignment, realign
them so that the tractor holes match up.
units?
Arethetractorunits tooclose
Misalignment of the tractor units, making the paper too
or too far apart?
close or too tight, will prevent a smooth paper feed.
Are the ~actor units locked
Correct this if necessary.
in position and the covers
closed?
132