Dot Matrix Printer Users Manual

Switch B-2: Paper-out

When this switch isOFF the printer ignores the paper-out detector and

prints down to (and beyond) the bottom edge.

Switch B-4: This switch is used for technical purpose only. Leave this

switch ON.

Switch B-5: Printable area

This printer can use two types of printing area format for single sheets

(cut forms).

By putting the switch ON (’<TypeA“), thetop ofthe first lineofprinting

will start 1/6inchfrom thetop of thepaper, and theprinted area willend

1/6 inch from the bottom of the paper.

By putting the switch OFF (“Type B“),the first lineof printing will start

at one inch from the top of the paper, and the printed area will end to

print 6 mm from the bottom of the printer.

Switches -C-l and C-2: Print Mode

These switches select the default print pitch and the fonts as shown

below.

Print Mode

c-l c-2

10CPIDRAFT

ON ON

10CPI HS DRAFT

OFF

17CPI DRAFT

OFF ON

10CPI LQ

OFF OFF

NOTE: If you change these switches after you have saved a macro,

these new settings will override the macro setting.