User Manual

– 31 –
11. DIP Switch Settings
ere are DIP switches located on the bottom of the printer and various settings can be per-
formed as shown in the following table.
When changing the settings, use the following procedure.
(1) Turn the printer o and disconnect the power cable plug from the AC outlet.
(2) Remove the screw, and then remove the DIP switch cover on the bottom of the printer.
(3) Use a tool with a narrow tip to change the DIP switch settings.
(4) Install the DIP switch cover and secure it with the screw.
Note:e new settings will take eect aer the printer is turned on.
DIP Switch 1
Switch Function ON OFF
1-1 Reserved Fixed -
1-2 Reserved Fixed -
1-3 IP address acquisition time-out setting *2 20 seconds No time-out
1-4 Initialize network settings *1 Valid Invalid
e factory settings of DIP Switch are all on.
(*1)
Initialize network settings procedure
1. Turn the printer o.
2. Set DIPSW1-4 to OFF when the power is on, and wait for approximately 15 seconds.
3. Set DIPSW1-4 to ON to turn the power on again.
Note: Because the following functions are unavailable when DIPSW1-4 is set to OFF,
make sure you set DIPSW1-4 to ON.
- Printing (self-print is available)
- TELNET server
1 2 3 4
DIP switch1
ONOFF