User Manual
Table Of Contents
- TSP100LANHardware Manual
- TABLE OF CONTENTS
- 1. Unpacking and Installation
- 2. Parts Identification and Nomenclature
- 3. Setup
- 4. Attaching the Accessories
- 5. Thermal Roll Paper Specification
- 6. Control Panel and Other Functions
- 7. Preventing and Clearing Paper Jams
- 8. Periodical Cleaning
- 9. Peripheral Unit Drive Circuit
- 10. Specifications
- 11. DIP Switch Settings
– 32 –
(*2)
Sets the timeout time when getting the address from a DHCP server. e factory default
setting (when set to ON) is 20 seconds.
When set to on, there is no timeout.
If this product is connected directly to an intelligent switch or intelligent hub, the physi-
cal link may take some time to become established. As a result, a timeout will occur while
waiting to get the DHCP address, and it will fail to get the IP address. In such cases, set
DIPSW1-3 = OFF to have no IP address acquisition timeout.
Note: is feature is supported from rmware version 3.0.
For the printer's rmware, contact your dealer.