Installation Instructions Part 1

16 Chapter:AboutThisGuide
iCell®QuadPACIP‐RANEV‐DOQuadPACInstallationandInitialConfigurationGuide
PartNumberD02698GSRevA1|November2013
STAR SOLUTIONS CONFIDENTIAL
TechnicalSpecifications Table 1liststheQuadPACtechnicalspecifications.
TheQuadPACsupportsiCellEV‐DOsoftwarerelease8.1.0orhigher.
OrderofTasks ThisQuadPACInstallationandInitialConfigurationGuidedescribesallthetasks
requiredtoinstallandconfigureaQuadPAC.Thisguidehasthreemainsections:
■ Pre‐Installation
■ Installation
■ InitialConfiguration
Followthetasksintheorderthattheyarepresentedtosuccessfullyinstalland
configuretheQuadPAC.
Table 1QuadPACTechnicalSpecifications
Capacity/Performance
RFconfiguration 1FA/1S
RFoutputpower Upto50mW(optionalconfigurationupto125mW)
CDMAtechnology EV‐DORevA,RevB
Channelelements 64
Packetdatarate(peakburst) EV‐DOpeakdatarates:
RevA‐3.1MbpsFwd/1.8MBbpsRev
RevB–4.9MbpsFwd/1.8MBbpsRev(percarrier)
FrequencyBands
BandClass0
BandClass1
BandClass5,BlockA
Tx:869–894MHz|Rx:824–849MHz
Tx:1930‐1990MHz|Rx:1850‐1910MHz
Tx:462.5‐467.5MHz|RX:452.5‐457.5MHz
ProtocolSupport
DO‐BTS/RNCinterfacesignaling Abis,A10,A11,A12,A13
Packetdata GRE/IP
Operations,Administration,and
Maintenanceinterface
SNMPv2c
Hardware
Dimensions 1UHx15inWx20inD
Nominalinputvoltage:
ANSIstandardC84.1/
CAN3‐235
120V(+10,10%)at60Hz
European 230V(+6,10%)at50Hz
Powerconsumption 100W(intypicaloperatingconditions)
Operatingtemperature 0to40degreesCelsius