Installation Instructions Part 1

50 Chapter4:InterfaceConnections
iCell®QuadPACIP‐RANEV‐DOQuadPACInstallationandInitialConfigurationGuide
PartNumberD02698GSRevA1|November2013
STAR SOLUTIONS CONFIDENTIAL
Warning:
Warning:
Caution:
PowerConnection ToconnectpowertotheQuadPAC:
1 EnsurethebreakerswitchonthePowerSupplyModuleisinthe"OFF"position.
2 ConnecttheACpowercable.
PowerconnectionstotheQuadPACmustcomplywithlocalsafetycodes.
Powerconnectionsmustbeperformedbyqualifiedpersonnelonly.
TopowertheQuadPACon,togglethe
powerswitchonthePowerSupplyModule
tothe"ON"position.(SeeFigure 22
.)
Figure 22ResetButtonandPowerBreakerSwitch
ResetButton TheResetbutton(seeFigure 22)isusedtoeffectdifferenttypesofresetonthe
QuadPAC,dependingonhowlongtheresetbuttonishelddown.
Theresetbutt onshouldnotbepressed duringpowerup.Doingsocancausethe
QuadPACtomalfunction,resultinginthepotentiallossofdata.
Table 15
liststheresetbuttontimingduringnormaloperations.
RESET
AC POWER SUPPLY
STARSOLUTIONS
TM
Reset
button
Power
switch
Table 15ResetButtonTiming
ButtonHoldTime(seconds) ResetAction
1 TheDO‐BTSisreset.
5 TheDO‐BTSispowercycled.TheLEDgoesoff.
20 Theunitisresettofactorydefaultsettings.