User's Manual

MovingMedia 2000 iCell Pico BTS Installation Guide Page 16 of 16
3.4.2.1 Connecting to GPS
To Connect GPS:
• Connect the GPS receiver ANT F-Type connector the GPS antenna cable.
• Connect the GPS receiver SERIAL DB9 connector the BTS GPS
TOD connector with cable MCN 45-89332.
• Connect the BNC T receiver adaptor (female) to the BTS 1 PPS IN
SMA connector with cable MCN 45-89800-1.
3.4.2.2 Miscellaneous Connections
To connect the remainder connections:
• Connect BTS Primary Ethernet port through Internet switch to BTS.
• Connect BTS S1 Tx/RX1 to external antenna
or to DAS for typical omni configuration.
• Rx diversity is not normally required for Pico
in-building deployments.
• All unused SMA connectors should be terminated.
• For wall mount Pico, connect 4 pin DIN cable from AC adapter output to
BTS 5.2VDC input and connect AC adapter to 110 or 220 V AC supply
• For AC Rack mount version, just connect the AC cord to 110 or 220 V AC
supply.
• For DC Rack Mount version, make sure the main rack breaker is off and the
BTS power switch is in the off position. Connect the –48v wire as indicated
on the rear of the unit marked “–“ or “–48v” and the positive (Bat. Rtn) wire
to the terminal marked “+” or Bat Return.
The BTS unit is now ready for configuration and testing.