Quick Start Up Guide

QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR
COMPLETE DETAILS.
GARDEN HOSE UTILITY PUMP
MODELS HPP360, HPP12V, 473707
Outlet Inlet
Outlet
Inlet
Outlet Hose
Water Source
Outlet Inlet
3 ft. Max.
Vertical
1 2
3 4 5
Pump should be located so that the water source is within reach
of supplied 6 ft. inlet hose.
Install inlet hose on the inlet side of pump.
Attach 5/8 in. outlet hose (not included) on the outlet side of pump.
NOTE: Outlet hose should be as short as possible and no longer
than 25 ft.
To prime pump, ll the pump cavity through inlet to wet impeller.
Connect supplied 6 ft. inlet hose and submerge below surface of
water. Turn on pump.
Models HPP360 and
473707: Plug the cord
into a 3-wire, 115 volt, 60
Hz grounded A/C outlet
protected by a ground-
fault circuit interruptor.
This unit is shipped with a Puddle Vac accessory for removing
water from at surfaces.
CAUTION: Before water is completely gone, unplug the pump.
DO NOT RUN PUMP DRY!
023912 B
PRIMING INSTRUCTIONS:
IMPORTANT:
Pump MUST be primed before it is turned on.
OPERATING
INSTRUCTIONS:
IMPORTANT: For best
results, DO NOT COIL
OR kINk THE HOSES.
PUMP LOCATION: ATTACHING HOSES:
TURNING PUMP ON:
Model HPP12V:
Attach red
battery clip to
positive terminal
and black battery
clip to negative
terminal of a fully
charged battery.
Outlet Hose
Water
Source
Discharge
Water
Battery
Negative
Terminal
Black Battery
Clip
Positive
Terminal
Red
Battery
Clip
Description Quantity
Pump 115V or 12V 1
Inlet Hose 1
Puddle Vac 1
MODEL # HPP12V MODEL # HPP360 / 473707