BLADE SOLD SEPARATELY
OPERATION PRIOR TO OPERATION 1. Power source: Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate. 2. Power switch: Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the power switch is in the ON position, the power tool will start operating immediately, which can cause a serious accident. 3.
OPERATION NOTE Always use the provided wrench to secure the belt. • Be careful because the bolt tightens to the left (counter-clockwise direction to prevent it from being loosened during cutting. 2. Removal Remove the bolt with the provided wrench and remove the diamond wheel. CUTTING 1.Wheel guard adjustment Adjust the wheel guard angle with the knob so dust and debris from the material or sparks do not contact the operator during the cutting operation. 2.
OPERATION • Check that the blade is not in contact with anything when the machine is started. • Always cut at the maximum speed • Start cutting smoothly, allowing the machine to work without forcing or pressing the blade. • Move the blade slowly forwards and backwards to achieve a small contact area between the blade and the material to be cut. This reduces the temperature of the blade and ensures effective cutting. • Feed down the machine in line with the blade.
MAINTENANCE 1. Inspection of the diamond wheel A worn diamond wheel overloads the motor and reduces working efficiency. Replace it with a new one. 2. Inspecting the mounting screws Regularly inspect all mounting screws and ensure that they are property tightened Should any of the screw's be lose, retighten them immediately. Failure to do so can result in serious injury. 3. Maintenance of the motor Exercise due care to ensure the winding does not become damaged and/or wet with oil or water. 4.
PARTS DIAGRAM 10
PARTS LIST 11
12