User Manual

3
Switch (2) can be switched in three positions:
- Mode I lower temperature and less the volume of blowing air;
- Mode II higher the temperature and more the volume of blowing air;
- Middle position – the tool is switched off.
Mode I can be used for warming the cool work-piece or drying the varnished surface..
After switching the tool on wait for one minute and start operating.
During the operation
 during long work don’t allow overloading and overheating, make work breaks;
 avoid mechanical damage of the machine;
 keep the machine away of intense heat sources and reactive materials, don’t allow
liquids and other matters come inside the machine;
 don’t not block ventilation slots in the housing;
 switch off the machine by the way of turning off the switch before disconnecting the
cable.
After work
 switch off the machine and disconnect the cable from the current source;
 clean the machine and accessories;
 keep the machine in conditions of temperature from +1°С to +35°С and humidity
not more than 80%.
Maintenance
This tool doesn’t require special technical maintenance.
Safety instruction when working with hot air
gun
1. Wear individual protection equipment if necessary (gloves, shoes, goggles, air filters,
etc.), according to the work you have to do.
2. Disconnect the machine when it is not in use, when changing nozzles or for any
maintenance.
3. Work in a clean and not cluttered area.
4. Always keep a stable and sure position when working. Work area should be correctly
lit.
5. Store the appliance in a dry place, far from sources of heat or dangerous vapors when
it is completely cold (at least 30 minutes after work).