Use and Care Manual

ASSEMBLY

INSTALLING THE TABLE

1. Locate table (#11) and remove the protective paper.

2. Place the table on the arm of bracket assembly (Fig. 1).

3. Align the table to base.

4. Secure table to arm by tightening clamp bolt. (Fig. 2)

INSTALLING THE HEAD ASSEMBLY

1. Locate head assembly (#1).

2. Put head assembly over column and align the hole on the bottom of the head

assembly to the column and slide the head assembly down the column.

3. Align the head frame with the table and base.

4. Secure the head assembly to the column by set screws on left side of the

head.

5. Tighten with hex key wrench. (Fig 1)

INSTALLING THE FEED HANDLES

1. Locate arbor (#10), chuck (#9) and chuck key among parts bag.

2. Remove the protective polylm from these and discard.

3. Clean out the tapered hole in the chuck and arbor (Fig. 1)

4. Insert arbor into spindle and turn the arbor around to make it all the way in the spindle. Firmly tap the arbor

nose with rubber mallet or a piece of wood (Fig. 2)

5. Open chuck jaws completely by turning chuck sleeve counter-clockwise to the end. (Fig 4)

6. Push the chuck up on the arbor nose as far as it will go (Fig 5).

7. Firmly tap the nose of chuck with rubber mallet or a piece of wood to insure proper seating of the chuck

on the spindle.