Use and Care Manual

ASSEMBLY
5
WARNING: For your own safety, never connect plug to power source until all assembly steps are completed.
TOOLS NEEDED TO ASSEMBLE
6” or 8” adjustable wrench, #2 Phillips stubby screwdriver, 16 oz rubber mallet and combination square.
ASSEMBLY OF BASE/COLUMN
1. Locate base (#4), column support ange (#5) and column (#2). Remove protective covering paper and
discard.
2. Position base on the oor.
3. Place column support ange on the base and align holes in the support ange with holes in the base.
(Fig. 1)
4. Locate four (4) hex bolts, four (4) washers among loose parts in bag.
5. Install a bolt, washer and lock washer in each hole through the support ange and base and tighten with
adjustable wrench. (Fig. 2)
6. Slide the column into the column support ange and tighten the set screw furnished on the ange with
hex key wrench
INSTALLATION OF BRACKET ASSEMBLY
1. Locate bracket assembly (#3), crane handle (#2) and rack (#6).
2. Put bracket assembly over the column, align the hole of table bracket with column and then insert rack
with teeth face outside half way through the hole between bracket and column. (Fig. 1).
3. Slide the bracket assembly into the rack and column to the position you want. (Fig 2).
4. Install crane handle to the shaft and tighten with hex key wrench. (Fig. 3).
5. Adjusting the rack to proper position by turning crane handle until the bottom of rack reach the column
support ange edge. (Fig. 4)
6. Secure the rack by installing rack ring. (Fig. 5)
7. Secure the bracket assembly to the column by tightening lock handle. (Fig 6)