Use and Care Manual

ASSEMBLY

INSTALL THE CHUCK

1. Inspect and clean the taper hole in the chuck and the spindle. Remove all grease, coatings and particles

from the chuck and spindle surfaces with a clean cloth. 2. Open the chuck jaws by turning the chuck barrel

clockwise by hand. Make sure the jaws are completely recessed inside the chuck. 3. Seat the chuck on the

spindle by placing a block of wood under the chuck by tapping the wood with a hammer or tap the chuck with

a rubber mallet.

CAUTION: To avoid damaging the chuck, make sure the jaws are completely recessed into the chuck. DO

NOT use a metal hammer directly to drive the chuck into the spindle.

REMOVE THE CHUCK AT A LATER TIME

1. Turn the feed handles to lower the chuck (2) to the lowest position. 2. Place a ball joint separator tool (not

included) above the chuck (3) and tap it lightly with a hammer (4) to cause the chuck to drop from the spindle.

NOTE: To avoid possible damage, be prepared to catch the chuck as it falls.

BATTERY ASSEMBLY

1. Take off the battery cover (3) and insert two AAA batteries into the laser box

(1). make sure the anode + and cathode - of the battery is in according to the

marks on the battery cover.. 2. Put the battery cover (3) into the laser box (1).

3. Seat the chuck on the spindle by placing a block of wood under the chuck

by tapping the wood with a hammer or tap the chuck with a rubber mallet.

NOTE: The laser box is assembled at the factory and is preset for best function.

Laser Class 2 <1mW