Use and Care Manual

ASSEMBLY

TOOLS NEEDED FOR ASSEMBLY

Adjustable Wrench, hammer, block of wood, screwdriver

BASE TO COLUMN

1. Place Column (1) on the Base (2) and align holes in the Column with the holes in the base. 2. Attach

using a Bolt, Spring Washer, and Washer (2) in each hole through the Column and into the Base.

TABLE TO COLUMN

1. Loosen the Pivot Lever (3) on the table (2) 2. Slide the Table (2) over the Column (1). 3. Tighten the

Pivot Lever (3) to secure the Table (2) in place.

DRILL PRESS HEAD TO COLUMN

1. Lift the drill press head assembly (1) carefully and place the mounting hole of the drill press head onto

the top of the column (3). Make sure the head is seated properly on the column. 2. Align the direction of

the drill press head to the direction of the base and table. 3. Tighten the set screws (2) using the wrench.

4. Thread the three feed handle rods (4) into the holes on the feed hub. 5. Hand tighten.

NOTE: One or two of the feed handles may be removed if an unusually shaped workpiece interferes with

handle rotation.