Use and Care Manual

SET SCREEN CONTRAST
The default setting for the LCD screen is 3. Screen contrast levels can be adjusted from 0 to 7 units for low
or high lighting conditions. Note: Changes to the contrast setting do not update instantaneously. Changes to
this setting must be saved before the contrast level changes.
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select “Settings”.
4. Use the Up or Down arrow to scroll to “Device” and press Select.
5. Use the Up or Down arrow to scroll to “Contrast Level.”
6. Press Select. Screen will show current contrast setting number. Use Up or Down to change number.
7. Press Save to save. To cancel any changes, press Back to exit without saving.
8. Press the Back button to exit.
DIGITAL CONTROL INTERFACE
9
SET CONTROL PANEL LANGUAGE
To access the language menu:
1. Check that the green power LED is on.
2. Press Menu and press Select to select “Settings”.
3. Use the Up or Down arrows and scroll to “Device” and press Select.
4. Use the Up or Down arrows to scroll to “Select Language and press Select.
5. Use the Up or Down arrows to choose the desired language.
6. Press Save to select the control panel language. To cancel any changes, press Back to exit without
saving.
7. Press Back to exit.
SET TEMPERATURE UNIT
The default setting is Fahrenheit (°F). The pump can be set to either Celsius (°C) or Fahrenheit (°F).
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select “Settings”.
4. Use the Up or Down arrows to scroll to “Device” menu item. Press Select.
5. Use Up or Down arrows to scroll to “Temperature Units” and press Select.
6. Use Up or Down arrows to choose Celsius (°C) or Fahrenheit (°F).
7. Press Save to save. To cancel any changes, press Back to exit without saving.
8. Press Back to exit.
SET CONTROL PANEL LANGUAGE
Password Protection
The default setting for password protection is disabled. When this feature is enabled, the pump display will
prompt for the password before allowing access to the control panel and buttons. The entered password is
any combination of four (4) digits.
• The pump can always be stopped by pressing Start/ Stop, even when password protection is enabled.
• Password protection cannot be turned back on with Start/Stop while running in manual mode.
• Pressing Start/Stop when the pump is off will return it back to the Running Cycles Mode and run at
the next scheduled run time. If the present time is within the scheduled run time, the pump will run the
scheduled speed.
• All functions including programming are disabled in Password Protection Mode.
• Screen will read “Enter Password” if any button other than the Start/Stop button is pressed
• Key icon displayed in the upper left side of the screen when Password Protection is on.