Use and Care Manual
DIGITAL CONTROL INTERFACE
10
SETTING PASSWORD
1. Check that the green power LED is on.
2. Press Menu. Press Select to select “Settings”.
3. Use the Up or Down arrow to scroll to “Device”.
4. Press Select.
5. Press Up or Down arrow to scroll to “Password”. The default setting is “Disabled”.
6. Press Select.
7. Press Up or Down arrow to change the setting to “Enabled”. Press Save to save.
8. Press the Down arrow. “Password Timeout” will be displayed. The factory default time is 1 minute. This
means the Variable Speed Pump will go into Password Protection mode 1 minute after the last control
panel key is pressed.
9. Press Select to change time setting from 1 minute to 6 hours and press Save to save.
10. Press the Down arrow and then press Select on “Enter Password” to change the setting.
11. Press the Left or Right arrows to move cursor and press the Up or Down arrow to change the
password number to desired setting.
12. Press Save to save. To cancel any changes, press Back to exit without saving.
Entering Password
1. Press any button (besides the speed button) to prompt the screen for a password.
2. To enter password, use the Left and Right arrows to move the cursor and the Up and Down arrow button
to scroll through the digit then press Save to conrm.
PUMP OPERATING MODES
The Variable Speed Pump can be programmed in three different modes: Manual, Schedule, and Egg Timer.
Speeds 1-4 can be programmed in all three modes. Speeds 5-8 can only be programmed in Schedule
mode since there are no buttons on the control panel for Speeds 5-8. The default setting for Speeds 5-8 is
“Disabled”.
MANUAL
Assigns a speed to one of the four Speed buttons on the control panel. This mode can only be used for
speeds 1-4. To operate in Manual mode, press one of the four speed buttons and then press the Start/Stop
button. The pump will run the assigned speed for that speed button.
EGG TIMER
Speeds 1-4 can be programmed to run at a certain speed and for a duration of time once a speed button
is pressed. Speeds 3 and 4 are Egg Timers by default. If you desire a different method of operation, speeds
3 and 4 can be changed to Manual mode in the control menu. To operate in Egg Timer mode, press a speed
button and then press Start/Stop. The pump will run that speed for the set amount of time and then turn off.
SCHEDULE
Program speeds 1-8 start and stop at a specic time during a 24 hour period. Speeds programmed in
Schedule mode will override any manually selected speed (speeds set by manually pressing any of the
speed buttons on the control panel).