Use and Care Manual

DIGITAL CONTROL INTERFACE
EXTERNAL CONTROL
This function is for programming speeds that will run when the automation control system sends it a command.
For example, Terminal 3 and 4 in the automation system will correspond to External Control Program #1. (5
and 6 to Ext Ctrl #2). The Stop Delay feature allows the user to program the pump to run a Program Speed
after the External Control has been deactivated. This feature can be used to provide a cooling down period
for the pump after a trigger signal from an installed heater has been deactivated. Each individual Program
Speed can have a Stop Delay of 1 to 10 minutes rogrammed. Use the External Control feature to program
the system power center
To access the External Control menu:
1. Check that the green power LED is on.
2. Press the Menu button.
3. Use Up or Down arrow to scroll to “Ext. Ctrl.”.
4. Press Select. “Program 1” is displayed.
5. Press Select. “750 RPM’ is displayed.
6. Press Select. The “RPM” number will highlight.
7. Press Up or Down arrow to change the RPM setting.
8. Press Save to save the setting. Note: To cancel any changes, press the Back button to exit without
saving.
9. If you do not wish to program a Stop Delay, continue to step 13. If you do wish to program a Stop delay
press Up or Down arrow to scroll to “Stop Delay”.
10. Press Select to set Stop Delay.
11. Press Up or Down arrows to change the Stop Delay setting. Stop Delay can be set from 0 minutes
(disabled) to 10 minutes.
12. Press Save to save the setting. Note: To cancel any changes, press the Back button to exit without
saving.
13. Press Back to return to set Program 2.
14. Use Up or Down arrow to scroll to “Program 2”.
15. Repeat Steps 5 through 13 to set Program 2, 3, and 4.
12
TIME OUT
The Time Out feature keeps the pump from running it’s programmed speeds for a set duration adjustable in
the menu. The Time Out feature is displayed in hours and minutes (Hrs:Mins). Once Time Out is nished,
the pump will return to its previous mode of operation, the Start/Stop LED will be lit and ready to turn on at
the next scheduled run time.
To access the Time Out menu:
1. Check that the green power LED is on.
2. Press Menu.
3. Use Up or Down arrows to scroll to “Features”, then press Select.
4. Press Select to choose “Timeout”.
5. Then press Select again to choose “Timeout Duration”.
6. Press Select to change the time. The cursor will highlight the minutes column.
7. Press the Left arrow to move cursor to the hours column. Time out can be set from 1 minute to 10
hours.
8. Press Save to save the setting.
Note: To cancel any changes, press Back to exit without saving.
9. Press Back to exit the menu.
QUICK CLEAN
This feature can be used to increase the pump speed for vacuuming, cleaning, adding chemicals, after a
storm for extra skimming capability. Press the Quick Clean button (LED on) and then Start/Stop to start.
When the Quick Clean cycle is over, the pump will resume regular schedules and be in “Running Schedule”
mode.