Use and Care Manual

QUICK CLEAN (CONT.)
1. Check that the green power LED is on and the pump is stopped.
2. Press Menu.
3. Use Up or Down arrows to scroll to “Features”, then press Select.
4. Press the Down arrow and press Select for “Quick Clean”.
5. Press Select to choose “Set Speed”.
6. Press Select to highlight the “RPM” rst (ones) column and change the speed.
7. Use Up or Down arrows to change the speed.
8. Press Save to save the speed.
9. Press the Down arrow again, and press Select for “Time Duration”.
10. Press Select to change the time. The cursor will highlight the minutes column.
11. Use Up or Down arrows to change the time from 1 minute to 10 hours.
12. Press Save to save the time.
13. Press Back to exit the menu.
DIGITAL CONTROL INTERFACE
PUMP MENU: PRIMING
The default setting for Priming is ENABLED. This setting allows the pump to automatically detect if it is
primed for startup. The priming feature increases the pump speed to 1800 RPM and pauses for three (3)
seconds. If there is sufcient water ow in the pump basket, the pump will go out of priming mode and run
its commanded speed. If the water ow is not sufcient, the pump speed will increase to the “Max Speed”
setting and remain for the priming delay time (default 20 seconds). If there is sufcient water ow in the
pump basket at this time, it will exit priming mode and transition to the commanded speed. If there is still
insufcient ow in the pump basket, as determined by the Priming Range setting, the pump will try to prime
at the “Priming Speed” for the amount of time set in the “Maximum Priming Time” menu, unless
the set “Maximum Speed” is lower than the set “Priming Speed”. Once the pump achieves prime, it will
resume normal operation after the preset priming delay.
NOTE
It is possible to set “Maximum Speed” too low for the pump to properly prime. Maximum Speed will limit
Priming Speed, except in one case. If the Maximum Speed is set below the lowest available Priming Speed
(2350 RPM) then the pump will exceed the Maximum Speed while the priming feature is running. This
prevents the pump from having trouble priming if the Maximum Speed is set this low. If this is a problem,
priming can be disabled in the Priming Menu.
PRIMING FEATURES
DISABLED/ENABLED: Default: ENABLED
Allows Variable Speed Pump to automatically detect if pump if is primed for startup. The pump will speed up
to 1800 RPM and pause for three (3) seconds - if there is enough water in the basket, the pump will go out
of priming mode and run the commanded speed.
SET SPEED: Default: 3450 RPM
The priming speed can be set between 3450 RPM and 2350 RPM. If the pump is on an equipment pad
that is close to the water level, it will not need to run at 3450 RPM to successfully prime. The setting can be
lowered to prevent running at a higher speed than necessary. Day to day factors (i.e. local ambient pressure,
water/air temperatures, amount of water retained from last system run) can effect priming performance.
Because of the frequently changing nature of these factors the priming speed should be set high enough
to accommodate environmental and mechanical changes to ensure that the pump can successfully prime.
Finding the most effective and efcient speed for your specic needs may take careful testing and evaluation
of priming performance.
MAX PRIMING TIME: Default: 11 MINUTES
The maximum priming time can be set from 1 - 30 minutes. This setting is the amount of time the pump will
try to prime before it gives a priming error. If this occurs, ll the pump basket with water and restart the pump.
13