Use and Care Manual

DIGITAL CONTROL INTERFACE

PUMP MENU: THERMAL MODE

The sensor for Thermal Mode is in the drive, on top of the motor. This feature allows you to set a speed

(450 RPM - 3450 RPM) that runs when the Variable Speed Pump goes into Thermal Mode. The

temperature level that you wish Thermal Mode to start can also be set. IMPORTANT NOTE: This feature

is for protection of the pump. Do not depend on the Thermal Mode feature for freeze protection of the pool.

Certain situations could cause the pump to sense a different temperature than actual air temperature.

Your automation systems air temperature sensor should be used to sense actual temperature. For example,

if the pump is located indoors, the temperature of the room does not indicate the outdoor temperature. The

pump does not sense the water temperature.

To access the Thermal Mode menu:

1. Check that the green power LED is on.

2. Press Menu.

3. Use the Down arrow to scroll to “Thermal Mode” and press Select.

4. The factory default for Thermal Mode is “Enabled“. To disable Thermal Mode, press Select to highlight

“Enabled”.

5. Press the Up arrow - “Disabled” is displayed.

6. Press Save to save.

To Set Thermal Mode Speed and Pump Temperature:

1. With “Thermal Mode” displayed on the screen, press the Down arrow - “Set Speed” is displayed.

The factory default is 1000 RPM.

2. Press Select to change the speed. The cursor will highlight the rst column (ones).

3. Use the Up or Down arrows to set speed (450 -3450 RPM).

4. Press Save to save the speed.

5. Press the Down arrow to Pump Temperature (the temperature the pump will activate Thermal Mode,

default is 40° F/4.4° C).

6. Press Select to change the setting. The cursor will highlight the rst column. Can be set 40° F to 50°

F (4.4° C - 10° C).

7. Press Save to save the temperature setting.

Note: To cancel any changes, press Back to exit without saving.

8. Press Back to exit.

Pump Performance Curves