Use and Care Manual

8
DIGITAL CONTROL INTERFACE
SET DATE AND TIME
The time controls all scheduled times, functions, and programmed cycles and stores the correct time for up
to 96 hours after power is turned off. Reset if the power is off longer than 96 hours.
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select “Settings”.
4. Use the Up or Down arrows to scroll to “Date and Time” and press Select.
5. Press Select again and use Up or Down arrows to set the date.
6. Press Save to save user input and return to “Date and Time.”
7. Use the Up or Down arrows to scroll to “Time” and press Select.
8. Use the Up or Down arrows to scroll to set the time. Note: To set AM/PM or a 24 hour clock see the next
section “Set AM/PM or 24 Hour Clock.”
9. Press Save to save. To cancel any changes, press Back to exit without saving.
10. Press Back to exit.
SET AM/PM OR 24 HOUR CLOCK
To change the time from a 12 hour clock (AM/PM) to a 24 hour clock:
1. Press Menu.
2. Press Select to select “Settings”.
3. Use the Up or Down arrows to scroll to “Date and Time” and press Select.
4. Use the Up or Down arrows to scroll to “AM/PM” and press Select.
5. Use the Up or Down arrows to scroll to choose between 24 hr. and AM/PM.
6. Press Save to save. To cancel any changes, press Back to exit without saving.
7. Press Back to exit.
SET MINIMUM SPEED (RPM)
The minimum pump speed can be set from 450 RPM to 1700 RPM. The default setting is 450 RPM.
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select “Settings”.
4. Use the Up or Down arrows to scroll to “Min/Max”.
5. Use the Up or Down arrows to scroll to “Set Min Spd”.
6 . P r e s s S e l e c t t o c h a n g e t h e s e t t i n g . T h e c u r s o r w i l l a p p e a r i n t h e  r s t n u m b e r c o l u m n ( o n e s ) .
7. Press the Up or Down arrows to change the minimum speed setting from 450 to 1700 RPM.
8. Press Save to save. To cancel, press Back to exit edit mode without saving.
9. Press Back to exit.
PUMP ADDRESS
Use this setting if your pump is connected via the port to a automation system. The default pump address
is #1 and only needs to be changed when there is more than one pump on an automation system. When
multiple pumps are on the same system, you may change each pump’s address to allow the automation
system to send a command to the correct pump. The pump address can be set from 1-16. Refer to the
automation system manual for further details on how to connect and use an automation system with your
variable speed pump.
1. Be sure the green power LED is on and the pump is stopped.
2. Press Menu.
3. Press Select to select “Settings”.
4. Use the Up or Down arrows to scroll to “Device” and press Select.
5. Use the Up or Down arrows to scroll to “Pump Address” and press Select.
6. Press Up or Down arrows to change the address number from 1-16.
7. Press Save to save. To cancel any changes, press Back to exit without saving.
8. Press Back to exit.