Replacement Part List

3
Always
keep lit cigarettes away from the chainsaw at all times.
If any fuel spillage occurs during refueling use a dry rag to wipe up spills before turning the engine on.
After refueling, screw the furl cap back on tightly onto the fuel tank and the carry the product to an area
that is approximately 10 feet away from where it was refueled before turning the engine on.
Keep handles dry, clean and free of oil or fuel mixture.
immediately after stopping the engine. Doing so can result in serious injury.
In order to maintain your product in proper working order, perform the maintenance and check operations
described in the manual at regular intervals.
Always be sure to turn off the engine before performing any maintenance procedures.
away from the body.
SAVE THESE WARNINGS
Machine Symbols: For safe operation and maintenance, symbols are carved in relief on this machine.
Please take a moment to locate these symbols on the chainsaw.
A) The port to refuel the “Mix Gasoline”, located on the Fuel Tank Cap
B) The port to refuel the “Chain Oil”, located on the Oil Cap
C) Switch indicator: Flipping the engine switch to the “O” (Stop) direction and
the engine will stop. Located on the rear left of the unit.
D) Choke indicator: Pulling out the Choke knob and the Choke closes. Located
on the rear right of the unit.
E) Chain Oil Adjuster Nut indicator:
F) H-Needle indicator: The position of the L-Needle and position of the Idle
Adjusting Screw. Located on the rear left on the unit.
IMPORTANT SAFETY INFORMATION