Replacement Part List

(1)

clutch side. Adjust according to your work conditions. (F13)

NOTE

every time when refueling the unit.

due to changes in operating conditions. Before adjusting carburetor, make sure

sure to adjust the carburetor with the bar chain attached. When adjusting, take the

following steps:

1. Stop the engine and screw in both H and L needles until they stop. Never force

them. Then set them back the initial number of turns as shown below.

H Needle: 1 3/8

L Needle 1 ¼

2. Start the engine and allow it to warm up at half-throttle

maximum, then set the needle back a quarter (1/4) turn counterclockwise.

4. Turn the idle adjusting screw (T) counterclockwise so that the chainsaw does

not turn. If idling speed is too slow, turn the screw clockwise.

5. Make a test cut and adjust the H Needle for best cutting power, not for

maximum speed.

(1) L Needle

(2) H Needle

(3) Idle Adjusting Screw

ADJUSTING THE CARBURETOR

Chain Brake: this machine is equipped with an automatic brake to stop chainsaw rotation upon upon

occurance of kickback while in saw cutting operation. The brake is automatically operated by iniertial force

front guard turned down to the suidebar. (F15). To release the brake, pull up the front guard toward the front

handle until you hear it click.

(1) Turn off the engine

(2) Holding the chainsaw horizontally, release your hand from the front handle, hit the tip of the guide bar to

the brake is not effective, ask our dealer inspection and repairing the engine.

(3) If being kept rotating at high speed with the brake engaged, can heat the clutch and cause a lot of

lever and keep the emgine idling.

ASSEMBLY AND OPERATION