User's Manual

54
Pairing Process
For TruLink Remote to interact with your hearing
instrument(s), you must first pair the Remote
with each hearing instrument. You only need to
pair TruLink Remote with a hearing instrument
one time, as they should automatically
recognize each other when both are powered
on and they are within wireless operating range.
You can pair TruLink Remote with a monaural
hearing instrument, or binaural hearing
instruments. For a binaural set, both hearing
instruments must be successfully paired during
the same pairing cycle. Trying to pair just one
binaural hearing instrument with the TruLink
Remote will result in failure. To cancel pairing
mode on TruLink Remote, simply move the
lower switch from Unlock (left) to Lock (right)
position.
To quickly start using TruLink Remote:
1. Insert battery and close door on
hearing instrument(s), and place
within 12 inches of TruLink
Remote
2. Move lower switch from Lock
(right) to Unlock (left) position
3. Press and hold the HOME
button for 5 seconds
4. After 5 seconds, both LEDs
start rapidly blinking
5. For Binaural Hearing Instruments,
• If the left LED becomes solid blue for
2+ seconds and right LED becomes
solid red for 2+ seconds, then the
binaural pairing was successful.
Otherwise, repeat steps 3 – 5.
For a Left Monaural Hearing Instrument,
• If the left LED becomes solid blue for
2 seconds, then the monaural pairing
was successful. Otherwise, repeat
steps 3 – 5.
For a Right Monaural Hearing Instrument,
• If the right LED becomes solid red for
2 seconds, then the monaural pairing
was successful. Otherwise, repeat
steps 3 – 5.
6. To verify your setup, pressing the Volume
Up or Volume Down button should cause
a hearing instrument volume adjustment.