User's Manual

LED
The LED indicator provides helpful information about
SurfLink Remote Microphone:
LED BEHAVIOR
SURFLINK REMOTE
MICROPHONE STATE
Off
• SurfLink Remote Microphone is off
and is not attached to a power
source
• If SurfLink Remote Microphone is
off and attached to a power source,
then battery is fully charged.
• If SurfLink Remote Microphone
appears on but is not operational,
then battery may need recharging.
Solid green
Battery is recharging and SurfLink
Remote Microphone is off
Green for
2 seconds
• SurfLink Remote Microphone
successfully powers on
• Recharging started
Slow pulsing red
Low battery state and SurfLink
Remote Microphone is on
Red for 2 seconds
• SurfLink Remote Microphone
powers off
Rapid blinking red
• Possible error condition, refer to
Troubleshooting section
Slow pulsing blue
• SurfLink Remote Microphone is
streaming audio
Rapid blinking blue
• SurfLink Remote Microphone is in
active syncing state
How to Wear
The SurfLink Remote Microphone can be affixed to
clothing or worn on a lanyard. For better performance,
SurfLink Remote Microphone should be within 8”
(20cm) of the speaker’s mouth.
Clip – Gently press the clip
as shown. Slide clip opening
onto clothing and release
clip. Ensure SurfLink Remote
Microphone is securely affixed
to clothing.
Lanyard (optional) –
1. Gently press the clip
as shown.
2. Insert lanyard loop into
clip opening and lift
loop toward top of clip.
Release clip. Ensure the
lanyard is securely attached to
SurfLink Remote Microphone.
Lanyards can be obtained from your hearing
professional (ask for part #53262-000).
TIP – To achieve better signal-to-noise performance,
a hearing professional can adjust (mute or attenuate)
your hearing instrument microphones during SurfLink
Remote Microphone use.
2
1
16 17
Operation
Operation