User Guide

ManualsBrandsStarkey ManualsHearing AidStarkey 2.4 GHz Remote Microphone + Hearing Aid

Pairing

The Remote Microphone + must be paired to interact with compatible 2.4 GHz hearing aids on the Thrive platform.

Pairing occurs once, then the hearing aids and Remote Microphone + will automatically recognize each other.

The Remote Microphone + can be paired within Inspire X or outside of Inspire X. The Remote Microphone +

can pair with up to eight Bluetooth

devices.*

Pairing within Inspire X

Launch Inspire X, connect and detect hearing aids.

Select Accessories on the left navigation bar.

Ensure the Remote Microphone + is powered on.

Place the hearing aids within six inches of the

Remote Microphone +.

Place the Remote Microphone + in pairing mode by

pressing the Input Mode and Volume Up buttons

simultaneously until the LED status indicator

alternately blinks blue and red.

Select Pair to put the hearing aids into pairing mode

Pairing is successful when the Remote Microphone +

image displays in the accessory screen

Use the drop-down menu below the streaming

accessories box to set “Hearing Aid Mic While

Streaming”. Mic Reduced (50%) is the default

Select the Information icon for pairing instructions if needed

FM Receiver Jack

Microphones

Multi-Function Button

Input Mode Button

Input Mode LEDs

Clip

MicroUSB Jack

Stream

Volume

Up/Down

QUICKTIP

2.4 GHz Remote

Microphone +

Summary of content (4 pages)

PAGE 1
Microphones QUICKTIP 2.4 GHz Remote Microphone + Multi-Function Button Input Mode Button Input Mode LEDs FM Receiver Jack Clip MicroUSB Jack Stream Volume Up/Down Pairing The Remote Microphone + must be paired to interact with compatible 2.4 GHz hearing aids on the Thrive platform. Pairing occurs once, then the hearing aids and Remote Microphone + will automatically recognize each other. The Remote Microphone + can be paired within Inspire X or outside of Inspire X.
PAGE 2
Pairing (Continued) Pairing outside of Inspire X Volume + 1 Power off any mobile phone or other accessories that were previously paired with the hearing aids. 2 Ensure the Remote Microphone + is powered on. 3 Power off, then power on the hearing aids to place in pairing mode. 4 Place the hearing aids within six inches of the Remote Microphone +. 5 Press the Input Mode and Volume Up buttons simultaneously for seven seconds until the LED status indicator alternately blinks blue and red.
PAGE 3
Input Mode 1 Press the Input Mode button to advance to the next available audio source. When cycling through input modes, the FM System and Line-In options will only be available when physically attached to the Remote Microphone +. 2 If the Input Mode LED is off, press the Input Mode button to temporarily illuminate the LED. 3 When the Remote Microphone + is powered off, it will remember the input mode that was last used and will return to that position when powered back on.
PAGE 4
Input Mode (Continued) Audio Source Options Loop System Line-In Remote Microphone + can receive audio via a built-in telecoil when using a Loop System. Wearing the Remote Microphone + in a vertical orientation provides the best performance. When a Line-In cable is attached via the microUSB Jack, the Remote Microphone + can receive audio from a mobile phone that’s not using a bluetooth technology, MP3 player, tablet or computer.