User's Manual

2. Docking Station

LAN Port: This is the port for the LAN, where you can connect to the Self-Guard with

your computer in remote places.

USB Port: This is the same USB port as in the Self-Guard’s body.

MIC, S1: MIC is where you put in the external microphone. S1 is the port number 1 for

the sensor input and output. Provided sensor cable has three wires. The white colored

wire is for S1, red colored wire is for MIC, and the striped wire is for the GND (Ground).

PWR, S2: PWR is where you get the power (below 300mA) from the battery (3.6 V –

4.2 V) of the Self-Guard or from the adaptor (5 V). If the adaptor is connected to the

Self- Guard, then it gets the power from the adaptor and the voltage is 5. If there is no

adaptor connected to the Self-Guard, then it uses the power from the battery and the

voltage is from 3.6 to 4.2. S2 means that it is the port number 2 for the sensor input

and output. Provided sensor cable has three wires. The white colored wire is for S2,

red colored wire is for PWR, and the striped wire is for the GND (Ground).

PWR, S3: PWR is where you get the power (below 300mA) from the battery (3.6 V –

4.2 V) of the Self-Guard or from the adaptor (5 V). If the adaptor is connected to the

Self- Guard, then it gets the power from the adaptor and the voltage is 5. If there is no