User's Manual

Be sure to turn off the cameras that are not connected to the Self-Guard in the

menu.

Read below instructions for the “BUTTON CAM” function if you have purchased a SG-

911-“Button Camera with Microphone”

1. Insert the Button Camera into the Self-Guard’s connector which is located on bottom

of the Self-Guard unit.

2. Turn on the “BUTTON CAM” function.

1. Turn off the “BUTTON CAM” function.

2. Remove Button Camera form the Self-Guard unit.

To use the button camera, be sure to connect the button camera to the Self-Guard unit

first, and then turn on the function for, “BUTTON CAM”. If “BUTTON CAM” function is

turned ON from the unit, you can go into the Record or Sleep modes using the remote

On/Off switch of the button camera. If you turn on the switch, then Self-Guard goes into

Recording mode, and Self-Guard stops to record and goes into Sleep mode if you turn

off the switch.

When you connect the button camera to the Self-Guard unit first and then turn On

“BUTTON CAM” function, then Self-Guard may go into either a Recording mode if the

remote On/Off switch is turned On, or a Sleep mode if the switch is turned Off, right

after you turn on “BUTTON CAM” function depending on the switch’s physical location.

Note that you are turning off the built-in microphone and all the cameras set “ON”, but

instead you are turning on the button camera and the microphone in it when you turn

On “BUTTON CAM” function. When you are not using the button camera, press ESC

button to go into the main menu. From this main menu, proceed into Camera Set and

turn Off “BUTTON CAM” function before you remove the button camera from the Self-

Guard unit. If you do not turn off “BUTTON CAM” function and remove the button