User's Manual

At dawn, the light becomes bright from dark, generating a lot of noise when the Self-

Guard is in such circumstance. And the Self-Guard may recognize those noises as a

motion. In this case, you can set this level to “H” or “HH” to cut the noise.

However, if you set the level to “H” or “HH”, then the motion detection algorithm of the

Self-Guard may recognize the actual small motions as noise, and does not record

those small motions. So, set the level to “M” except for the special cases.

4-2-1-7. MOTION AREA (Motion Detection)

Out of the whole recording area from the camera’s view, this function is used when you

want to detect motions for the specific areas that you have selected only. The whole

recording area is divided into 16 (128x128), 20 (160x128), and 25 (240x240, 320x240,

480x480, and 640x480) blocks depending on the resolution. You can move the cursor

among from the blocks by using the direction buttons, and press [ENT] to select (red

colored O) or cancel (blue colored -) specific blocks. After selecting all the blocks for

the motion detection, press [ESC] to escape from the “EDIT” mode and to go to the

four options below. Select “SAVE” and press [ENT] to save the selected blocks.

ALL: Select all blocks

CLEAR: Cancel all blocks

EDIT: Select/Cancel blocks

SAVE: Save and Exit

Caution: If you select “CLEAR” and save it by pressing [ENT], then the Self-Guard

does not record any images even if there is a motion, because no area is selected for

the Self-Guard to detect the motions. Accordingly, be sure to select at least one block

in order for the Self-Guard to detect and record the images.