User's Manual

Access Point” is used to connect to Self-Guard units from a remote place with the

provided remote software. If the wireless LAN does not operate normally, then this

GLOBAL IP will be indicated as 000.000.000.000.

4-5-2-3. IP/GW SET

This function is to set the address for IP, GATEWAY, and SUBNET MASK of the Self-

Guard. Use [△] and [▽] to change the value and [◁] and [▷] to move the cursor, and

then press [ENT] to save the changes. If you need to change the IP, GATEWAY,

SUBNET MASK of the Self-Guard, you should make changes for the Wireless-G

Access Point to change the settings. Refer to the User’s Guide (Wireless-G Access

Point) for detailed instruction.

Wireless-G Access Point uses DMZ to send the external data from Internet to the Self-

Guard, and the DMZ value is set as the Self-Guard’s default IP address

(192.168.10.130). When you change the IP address for the Self-Guard, you need to

change the IP address of DMZ settings of the Wireless-G Access Point. Refer to the

User’s Guide (Wireless-G Access Point) for detailed instructions on how to change this

value.

4-5-2-4. WEP/EMAIL SET