User's Manual

76
motion detected for selected time (1-9 sec., default 5 sec.) after the very last motion
detection. Self-Guard comes out of the sleep mode every 2 seconds to check if there is
a motion, and if it detects motion and audio, then it records audio. However, it does not
record audio when there is audio if there is no motion. This will result in discontinuance
audio sound during playback. Despite of the audio discontinuance, it is a very useful
function to extend the battery life for recording when Self-Guard is placed in a very loud
place.
When this function is set to ON
:
Self-Guard is programmed to record audio as soon as it detects an audio even if there
is no motion. When there is no motion or an audio, Self-Guard goes into sleep mode,
and check if there is a motion every 2 seconds. Self-Guard comes out of sleep mode
as soon as it detects audio sound even when it is in the sleep mode. In this mode, Self-
Guard is programmed to record with any audio detection, so you should be careful in
turning this function to ON in a loud place to prevent from wasting the battery.
When this function is set to CON
:
Self-Guard is programmed to record constantly regardless of audio or motion detection.
In this mode, battery gets consumed very fast requiring your attention. You are
recommended to use this mode only when you need to record very small audio sound
under the possible level of audio detection
4-9-3-8. ON/OFF INFO
It shows 10 last history of power ON/OFF. The date and time is recorded for each
power on and off. If the power of the Self-Guard is gone abnormally such as, detaching
the battery from the Self-Guard during the operation, then the Self-Guard will not
record it in the power off history. This information will tell you either Self-Guard was
turned on and off properly or not properly either by user or somebody else.