User guide

ManualsBrandsStarrett ManualsMeasuring instruments5001 Carbon Fiber Caliper

Light Weight

Carbon Fiber Calipers

No. 5001B Series

User’s Guide

INTRODUCTION

This Starrett product is designed for ease

of use and provides the ability to output

measurements to a variety of peripherals,

either through a traditional wire or by

connecting to a Starrett DataSure

Wireless Data Collection System End Node.

Changing Battery

If a “B” is displayed on the left side of the

display, the battery needs to be changed.

Remove cartridge and replace with Lithium

3V CR2032 battery. Changing the battery

will automatically reset the indicator to

factory defaults.

To remove the catridge, slide the battery

carrier (2) in the direction of the arrow

in Fig. 1. Remove the battery from the

carrier and replace it with a fresh CR2032

battery. Then, slide the carrier back into

the housing.

OPERATING INSTRUCTIONS

Button Functions

MODE and SET button operations are:

Press and Release and Press and Hold

ON / OFF

To turn gage ON:

Press and Release ON/OFF

To turn gage OFF:

Press and Hold ON/OFF

(Note: When the tool is turned on it will

remain in whichever mode it was in when

it was turned off.)

Fig. 1

Summary of content (4 pages)

PAGE 1
Light Weight Carbon Fiber Calipers No. 5001B Series User’s Guide INTRODUCTION This Starrett product is designed for ease of use and provides the ability to output measurements to a variety of peripherals, either through a traditional wire or by connecting to a Starrett DataSure® Wireless Data Collection System End Node. Changing Battery If a “B” is displayed on the left side of the display, the battery needs to be changed. Remove cartridge and replace with Lithium 3V CR2032 battery.
PAGE 2
Taking Measurements LCD Display Measurements can be taken from: SET, REF I, REF II, MIN / MAX, and TOLERANCE Modes 1. Indicator of Min Max Mode 2. Indicator of Reference Mode 3. Measured value 4. Negative sign 5. Battery life warning display 6. Indicating cursor for Preset and Tolerance 7. Indicator of Measuring unit 8. Indicator of Tolerance Mode 9. Indicator of Preset Mode 10. Indicator of Set Mode 11. Indicator of Set Mode Display .0005" / .010mm 12.
PAGE 3
Reference Mode RECALL PRESET REFERENCE VALUE Measuring in MIN / MAX Mode REF I and REF II Modes will allow for two independent preset values to be set up. Used to calibrate the gage to a preset value, provided REF I or REF II preset values have been set (See Entering Preset Reference Values). NOTE: The recalled value depends on the REF MODE the tool is in. To enter MIN / MAX MODE: Press and Hold MODE until MIN MAX and SET appears (Ex. REF I = 0.0000 / Zero, REF II = .
PAGE 4
Tolerance Mode Measuring in Tolerance Mode Data Transmission Used to set gage with upper and lower measurement tolerances. To enter TOLERANCE MODE: Press and Hold MODE until TOL appears This tool comes with an Opto-RS232 output port (Fig. 1 [3]) that allows data transmission thru a traditional wire to a variety of peripherals or by connecting to a Starrett DataSure® Wireless Data Collection System using a Cat.1500-3-1N end node.