Quick Start Guide

Instruction Manual
4
2. Slide the Hand Screw (13) through the bottom of the clamp and attach the Pressure
Plate (14) using the Male Round Washer (11), Female Round Washer (12) and
M4x15mm Phillips Screw (10).
3. Attach the completed Desk Clamp to base of the Support Post (1) using 4 M5x14mm
Hex Screws (9).
4. Place the EVA Cushion (4) beneath the Support Post (1) and then place the Desk
Clamp opening around the edge of your desktop in your desired location. Tighten by
hand to secure, ensuring that the clamp is making full contact with the desk surface.