Quick Start Guide

Instruction Manual
3
Note: The Desk Clamp can support a desk / table thickness from ¾ - 4.3in (20
– 110mm). Depending on the thickness of your desk / table, the clamp can be
adjusted smaller by removing the 4 screws and raising the bottom portion of the
clamp as shown below.
Installation
Warning! It is the installer’s responsibility to ensure that the combined weight of all
components does not exceed the maximum 7 kg (15.43 lbs) weight capacity of the
mounting arm.
Desk / Grommet Mounting
The Monitor Arm can be clamped to a desk / table, or mounted through a grommet
hole. Instructions for both will be provided in the following sections.
Desk Mount
1. Slide the 2-in-1 Clamp (2) opening around the edge of your desk in your desired
location. Tighten by hand to secure, ensuring that the Pressure Plate is making full
contact with the bottom of the desk surface.