Instruction manual
Instruction Manual
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
I T: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
P T: Guia do usuário - pt.startech.com
Manual Revision: 10/18/2013
For the most up-to-date information, please visit: www.startech.com
ET91000SFP2 / ET91000SFP2C
Gigabit Ethernet Fiber Media Converter Card Module with Open SFP Slot
Packaging Contents
ET91000SFP2
• 1 x Fiber Media Converter
• 1 x Universal Power Adapter (NA/EU/UK)
• Instruction Manual
System Requirements
• MSA Compliant Gigabit SFP Module
• 1000BASE-T compatible Ethernet network equipment
• RJ45 terminated UTP Cat5e or better Ethernet cable
• Available AC electrical outlet
ET91000SFP2C
• 1 x Fiber Media Converter
• Instruction Manual
Installation
1. Make sure the DIP switches are set appropriately for
your network conguration (see “DIP Switch Settings“
section for details).
2. Insert a compatible SFP module into the open SFP slot.
3. Connect a ber optic network cable from a computer /
switch / media converter to the inserted SFP connector
on the media converter.
NOTE: When connecting the ber cable to your installed SFP
module, make sure to connect the Tx (transmit) terminal on one end,
with the Rx (receive) terminal on the other end.
4. Connect a UTP Ethernet cable from a computer/switch
to the RJ45 jack on the media converter.
5. Connect the power adapter to the media converter.
Front
RJ45 Ethernet Connector
Dip Switch LED Indicators
SFP Slot
Rear
Thumb Screw
Release
DC Power Connector
Ground Point(Optional)
Installation into ETCHS2U Chassis
The ETCHS2U chassis supports the full line of StarTech.com ET series
2 media converters, which can be installed in a mixed fashion to suit
your environment. The cards are designed to be hot-swappable,
meaning the chassis need not be powered o in order to remove or
insert a card.
1. If the chassis slot was previously unused, loosen the screw at the
top of the slot to remove the cover plate
2. Align the card with the desired slot of the chassis and gently slide
the card into the groove to seat the power connection
3. Re-tighten the captive screw to hold the card in place