PCI Express eSATA/SATA 6Gbps Controller PEXESAT322I *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com For the most up-to-date information, please visit: www.startech.
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Introduction.............................................................................................1 Packaging Contents.................................................................................................................................. 1 System Requirements............................................................................................................................... 1 Installation..........................................................................
Introduction The PEXESAT322I PCI Express SATA III Controller Card (6 Gbps) gives you the option to add 2 internal or external SATA ports to your computer, through a single PCI Express (x1) card slot. The card features on board jumper selection, which enables you to configure the card to provide 2 internal or external SATA III ports, or one of each, as needed.
Internal/External Port Selection Jumpers 7-pin SATA ports 7-pin eSATA ports Installation WARNING! PCI Express cards, like all computer equipment, can be severely damaged by static electricity. Be sure that you are properly grounded before opening your computer case or touching your PCI Express card. StarTech.com recommends that you wear an anti-static strap when installing any computer component.
SATA 2 SATA 1 eSATA 2 eSATA 1 Jumper Position J1~J4 Active Port 1-2 Closed SATA 1 2-3 Closed (default) eSATA 1 J5~J8 1-2 Closed SATA 2 2-3 Closed (default) eSATA 2 Jumper Settings Of the 4 physical ports located on the card, only two of the ports can be active at a time. Selecting the ports you wish to activate is accomplished via the jumper blocks located on the card. Ports SATA 1 and eSATA1 are grouped together, while ports SATA 2 and eSATA 2 are grouped together.
Hardware Installation 1. Turn your computer off and any peripherals connected to the computer (i.e. Printers, external hard drives, etc.). Unplug the power cable from the rear of the power supply on the back of the computer and disconnect all peripheral devices. 2. Remove the cover from the computer case. See documentation for your computer system for details. 3.
Verifying Installation Windows From the main desktop, right-click on “My Computer” (“Computer” in Vista/7), then select Manage. In the new Computer Management window, select Device Manager from the left window panel. In the Device Manager, under the “IDE ATA/ATAPI controllers” category, you should see a new Asmedia SATA controller device listed.
Specifications PCI Express 2.0 (x1 slot connector) Host Interface SATA revision 3.0 Form Factor Full/Low Profile Chipset ID ASMedia AS1061 External Connectors 2 x 7-pin eSATA receptacle Internal Connectors 2 x 7-pin SATA receptacle Maximum Data Transfer Rate SATA III: 6 Gbps Port Multiplier Support Yes Operating Temperature 0°C ~ 50°C (32°F ~ 122°F) Storage Temperature -20°C ~ 60°C (-4°F ~ 140°F) Humidity 5% ~ 85% RH Dimensions 120.0mm x 67.0mm x 20.
Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty Information This product is backed by a two year warranty. In addition, StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.
