HDMI over Cat 5/6 Extender w/ Serial & IR – 330ft (100m) ST121HDBT5 *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com For the most up-to-date information, please visit: www.startech.
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Product Diagram.....................................................................................1 Front View - Transmitter / Receiver Unit............................................................................................ 1 Rear View - Transmitter/Receiver Unit................................................................................................ 1 Introduction.............................................................................................
Product Diagram Front View - Transmitter / Receiver Unit Link LEDs Status (Power) LED Rear View - Transmitter/Receiver Unit HDMI in port Link (RJ-45 Connector) IR out port IR in port Power jack Serial in port LAN Ports 1, 2, and 3 Grounding Bolt Serial out port IR in port IR out port HDMI out port Instruction Manual 1
Introduction Packaging Contents • 1 x HDMI extender • 1 x HDMI receiver • 2 x Mounting brackets • 1 x IR sensor kit (Transmitter cable \ Receiver cable) • 1 x CAT5 Cable • 2 x Foot pad set • 1 x Power Adapter • 2 x Grounding Wire • 1 x Instruction Manual System Requirements • HDMI® enabled video source device (i.e. computer, Blu-ray Player) • HDMI® enabled display device (i.e.
Preparing Your Site 1. Determine where the local video source (i.e. computer, Blu-ray Player) will be located and set up the device. 2. Determine where the remote display will be located and place/ mount the display appropriately. Note: This HDMI extender kit features Power over cable, allowing both the transmitter and Receiver to be powered from a single power source that connects to either the transmitter or receiver unit.
2. Install RJ45 terminated Cat5e/6 Ethernet Cable a) Connect an RJ45 terminated Cat5e/6 Ethernet cable (not included) to the RJ45 connector on the Transmitter unit. Note: If you are using surface cabling, ensure you have enough Category 5e unshielded twisted pair (UTP) network cabling to connect the Host Unit to the Remote Unit’s location, and that each end is terminated with a RJ45 connector. The cabling should not go through any networking equipment (i.e. router, switch).
Specifications 2x IrDA (Infrared; SIR/FIR) 1x HDMI (19 pin) Female Local Unit Connectors 4x RJ-45 Female 1x RS232 (9 pin) Female 2x IrDA (Infrared; SIR/FIR) 1x HDMI (19 pin) Female Remote Unit Connectors 4x RJ-45 Female 1x RS232 (9 pin) Male Maximum Data Transfer Rate HDMI - 3.
Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty Information This product is backed by a two year warranty. In addition, StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.
