Wall Plate HDMI® over Cat 5e/6 Extender - 165ft (50m) ST121HDWP *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com For the most up-to-date information, please visit: www.startech.
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Product Diagram.....................................................................................1 Front View – Transmitter/Receiver Unit.............................................................................................. 1 Rear View – Transmitter/Receiver Unit............................................................................................... 1 Introduction.............................................................................................
Product Diagram Front View – Transmitter/Receiver Unit Transmitter Unit Receiver Unit Status (Power) LED HDMI in Port HDMI out Port Power Adapter Port Power Adapter Port EDID Copy Rear View – Transmitter/Receiver Unit Transmitter Unit Receiver Unit Terminal Block Power Terminal Block Power Link Out 1 (RJ-45 Connector) Link Out 1 (RJ-45 Connector) Link Out 2 (RJ-45 Connector) Link Out 2 (RJ-45 Connector) Instruction Manual 1
Introduction Packaging Contents • 1 x Wall-mounted HDMI Extender • 1 x Wall-mounted HDMI Receiver • 1 x Universal Power Adapter (NA/UK/EU) • 1 x Instruction Manual System Requirements • HDMI-enabled video source device (i.e. computer, Blu-ray player) • HDMI-enabled display device (i.e. television, projector) • Available AC electrical outlet or DC terminated power source for either the transmitter or receiver • 2x HDMI cable (for video source to transmitter and receiver to display) Preparing Your Site 1.
Hardware Installation 1. Install the RJ45 terminated Cat5e/6 Ethernet cables to the transmitter and receiver units. a) Connect two RJ45 terminated Cat5e/6 Ethernet cables (not included) to the transmitter unit - one cable for the Link Out 1 RJ45 connector and another one for the Link Out 2 RJ45 connector. Note: Ensure that the Category 5/6 unshielded twisted pair (UTP) network cabling between the transmitter unit and the receiver unit has been properly terminated in a wall box in each location.
3. Install the transmitter and receiver units into the electrical boxes. a) Install the transmitter unit into the electrical box. Please follow the instructions included with your electrical box to determine which mounting points on the transmitter unit should be used. b) Install the receiver unit into the electrical box. Please follow the instructions included with your electrical box to determine which mounting points on the receiver unit should be used.
Note: If the LED flashes RED it is indicated the EDID copy procedure has failed. As a result of one of the following: • The display is not properly connected. • The display is not powered on. • The display does not support EDID. Please check your setup and attempt the EDID Configuration procedure again. Restore EDID to Factory Default Settings Follow the below steps to restore the EDID settings to factory default and remove any copied settings. 1.
Specifications Local Unit Connectors 1x HDMI (19 pin) Female / 2x RJ-45 Female Remote Unit Connectors 1x HDMI (19 pin) Female / 2x RJ-45 Female Maximum Data Transfer Rate HDMI - 3.
Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty Information This product is backed by a two year warranty. In addition, StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.
