HDMI® over Cat5 Video Extender with RS232 and IR Control ST121UTPHD2 *actual product may vary from photos DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com For the most up-to-date information, please visit: www.startech.
FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Table of Contents Introduction.............................................................................................1 Packaging Contents.................................................................................................................................. 1 System Requirements............................................................................................................................... 1 Transmitter Unit......................................................................
Introduction The ST121UTPHD2 HDMI® over Cat5 Extender Kit can extend the audio and video signal output from an HDMI®-equipped device by up to 330 feet (100 Meters), over a single CAT5 cable. The extender supports full High-Definition video (1080p) and HD 3D, and also extends the accompanying digital audio signal.
Transmitter Unit LINK LED FRONT HDCP MODE LED LED IR OUT HDMI IN LINK (RJ-45 Connector) REAR Power Jack (12V DC) Instruction Manual POWER LED RS-232 HDMI BYPASS 2
Receiver Unit FRONT LINK LED IR1 IN IR2 IN POWER LED HDCP MODE LED LED REAR LINK (RJ-45 Connector) Power Jack (12V DC) Instruction Manual RS-232 HDMI OUT 3
Preparing Your Site 1. Determine where the local video source (i.e. computer, Blu-ray Player) will be located and set up the device. 2. Determine where the remote display will be located and place/ mount the display appropriately. Notes: Ensure the Extender Unit and the Receiver Unit are situated near an available AC electrical outlet. Make sure all devices are turned off before beginning installation. Hardware Installation 1.
2. Install RJ45 terminated Cat5 Ethernet Cable a) Connect an RJ45 terminated Cat5 Ethernet cable (not included) to the RJ45 connector on the Transmitter unit. Note: If you are using surface cabling, ensure you have enough Category 5 unshielded twisted pair (UTP) network cabling to connect the Host Unit to the Remote Unit’s location, and that each end is terminated with a RJ45 connector. The cabling should not go through any networking equipment (i.e. router, switch).
Specifications 1x IrDA (Infrared; SIR/FIR) 2x HDMI (19 pin) Female Local Unit Connectors 1x DB-9 (9 pin; D-Sub) Female 1x RJ-45 Female 2x IrDA (Infrared; SIR/FIR) 1x HDMI (19 pin) Female Remote Unit Connectors 1x DB-9 (9 pin; D-Sub) Male 1x RJ-45 Female HDMI® - 3.
Technical Support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty Information This product is backed by a two year warranty. In addition, StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.