Switch User Manual

Instruction Manual
7
To select the audio signal from any port of 4 connected computers, the
user can press “FUNC” button in combination with the other pushbuttons.
Step 1.
Press and hold the “FUNC” button. Either all 4 green LEDs will illumi-
nate or just one green LED. If all four LEDs illuminate, the audio port is
operating on the same channel as the selected computer. This is known
as “tracking mode.” If just one green LED (the selected audio port) is
illuminated, the audio port is not on the same channel as the selected
computer (referred to as “non-tracking mode.”
Step 2.
While the “FUNC” button is being held down, press the pushbutton that
corresponds with the audio port you wish to select.
or
While the “FUNC” button is being held down, press and hold “1” AND “2”
to enter tracking mode.
Step 3.
Once the desired setting changes have been made, release “FUNC” but-
ton to exit the settings mode.