Datasheet

9
Scan Rate
Scan Rate sets the duration between switching to the next computer in Auto Scan mode:
left Ctrl + left Ctrl + F3
The StarView gives off one to four beeps indicating scan interval of 3, 8, 15 and 30 seconds respectively.
Keyboard Typematic Rate
You can adjust the keyboard typematic rate (given in characters/sec). This setting over-rides the keyboard
typematic rate of your BIOS and any operating system.
left Ctrl + left Ctrl + F4
The StarView gives off 1 to 4 beeps indicating 10, 15, 20 and 30 characters/sec respectively.
Audio Stick
An optional multimedia module can be LINKed to the back of each StarView for selecting microphone and
stereo speaker signals. There are two options for Audio Stick: On and Off. When set to On, audio selection
follows computer selection. When set to Off, audio selection stops following computer selection. It is
useful if you want to listen to a particular computer's audio signal while operating other computers.
left Ctrl + left Ctrl + F5
The StarView gives off 1 or 2 beeps corresponding to On and Off respectively.
Changing Your Configuration
After the initial power up, any device (either a KVM or a PC) can be added or removed from any PC x port
on the KVM without having to power down the Master KVM Switch. Make sure that devices are turned off
before connecting them to the Master KVM switch.
Note: After changing your configuration, the OSD will automatically update to reflect the new
configuration.