Datasheet

• The port number (or channel address) of the currently selected computer is displayed in red in the top

right of the screen.

• The device name is green if the device has power and is ready for selection or white if it has no power.

The OSD menu automatically updates the color when it is activated. On the 16-port models, use the

<Page Up> and <Page Down> keys to view the other 8 computers.

• Use the <UP>, <DOWN>, 1~8, or A~H keys to highlight a computer and <ENTER> to select it.

• Press <ESCAPE> to exit the OSD menu and remove the OSD menu from the screen.

• A triangle mark on the right side of the screen indicates the port is cascaded to a Slave KVM; the

number at the left of the triangle mark shows the number of ports the Slave has. With that port

highlighted, press <ENTER> to bring up a screen listing the computers connected to that Slave. The

name of the Slave KVM will be shown at the upper right corner of the OSD menu.

• An eye mark on the right side of the screen indicates that the computer has been selected to be

monitored in Scan mode. You can switch this mark on and off using function key <F2>.

• Press <ESCAPE> to exit the OSD and to return to using the selected computer. The computer name is

shown on the screen.

OSD Function Keys

You can use the function keys when the OSD menu is active.

Function key <F1>

Edits the name of a computer or a Slave KVM. First, use the <UP> and <DOWN> arrow keys to highlight

a channel then press <F1> followed by name entry. Your name can be up to 14 characters long. Valid

characters are A to Z, 0 to 9, and the dash character. Lowercase letters are converted to uppercase. Press

<BACKSPACE> to delete a letter one at a time. Non-volatile memory stores all name entries until you

change, even if the unit is powered down.

Function key <F2>

Marks a computer to be scanned by switching the eye mark on or off. First, use the <UP> and <DOWN>

arrow keys to highlight the device, then press <F2> to switch its eye mark on or off. If Scan Type is Ready

PC + Eye (see Function key <F4>), only the powered and eye-marked computers will be displayed in Scan

mode.